Operation
61
EMU28063
Shallow water
EMU40702
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
ECM02361
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU40712
Procedure for shallow water cruising
(1) Move the remote control lever to the
neutral position.
(2) Push the ā ā (up) side of the power trim
and tilt switch to tilt the outboard motor
up slightly to the desired position.
WARNING! Using the power trim and
tilt switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
1. Power trim and tilt switch
1. Power trim and tilt switch
1. Cooling water inlet
U6FN36E0.book Page 61 Tuesday, November 30, 2021 8:08 AM