8-54
8
2. Remove the tail/brake light bulb holder
(together with the bulb) by turning it
counterclockwise.
3. Push the burnt-out bulb in and turn it
counterclockwise to remove it from the
bulb holder.
4. Push a new bulb in and turn it clockwise
to install in the bulb holder.
5. Install the bulb holder (together with the
bulb) by turning it clockwise.
6. Install the panel.
7. Install the quick fastener screws, bolts,
and nuts, and then tighten the panel nuts
and the panel rear bolt to the specified
torques.
EBU32700
Troubleshooting
Although Yamaha vehicles receive an inspec-
tion before shipment from the factory, trouble
may occur during operation. Any problem in
the fuel, compression, or ignition systems can
cause poor starting and loss of power. The
troubleshooting chart describes a quick, easy
procedure for making checks. If your vehicle
requires any repair, take it to a Yamaha deal-
er.
1. Tail/brake light bulb holder
Tightening torques:
Panel nut:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Panel rear bolt:
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
UB5F7AE0.book Page 54 Tuesday, March 28, 2017 12:02 PM
To Next Page
Loading...
Need help?
General
