Name: Yamaha WR250F(D)
Brand: Yamaha
Rating: 5 (1 reviews)

To Next Page

To Previous Page

7-20

SIGNALING SYSTEM

INSPECTION STEPS

If the speedometer will not operate, use the following inspection steps.

*1 marked: Refer to "CHECKING AND CHARGING THE BATTERY" section in the CHAPTER 3.

• Remove the following parts before inspection.

1. Headlight

• Use the following special tools in this inspection.

*1 Check battery. No good → Recharge or replace.

OK ↓

Check each coupler and wire connection. No good → Repair or replace.

OK ↓

Check multi-function display. (Input voltage) No good → Replace wire harness.

OK ↓

Check multi-function display. (Output voltage) No good → Replace multi-function display.

OK ↓

Check speed sensor. No good → Replace.

Pocket tester:

YU-3112-C/90890-03112

Questions and Answers:

Need help?

Do you have a question about the Yamaha WR250F(D) and is the answer not in the manual?

Yamaha WR250F(D) Specifications

General