Why does the CLIP indicator light up on my Yamaha XM6150 Amplifier?
The CLIP indicator lights up because there is a short at the amplifier’s speaker outputs, the speaker’s inputs, or in the wiring. Locate and remove the short. It may also indicate that the impedance of the connected speaker is too low, so use a speaker with a minimum impedance of 4? (8? in Bridge mode).
Highlights key features like amplifier configuration, input/output options, and indicators.
Critical safety warnings regarding water, power cord, damage, and internal access.
Advice on ventilation, airflow, cable handling, proper plug usage, and phone interference.
Details POWER, PROTECTION, CLIP, and SIGNAL indicators on the front panel.
Controls for High Pass Filter (HPF) and input signal attenuation per channel.
Details balanced XLR and Euroblock connectors for input signals.
Settings for signal routing (CH A to ALL) and bridging channel pairs.
Grounding screw terminal for hum or noise reduction.
5-way binding posts for connecting speakers in normal and bridge modes.
Instructions on how to connect wires to Euroblock terminals.
Steps for connecting speaker cables to the output terminals.
Describes the forced cooling system and airflow path.
Guidelines for mounting the amplifier in a rack for proper ventilation.
Lists power output, frequency response, distortion, and other technical parameters.
To Next Page
General
