Instrument and control functions
4-8
1
2
3
4
5
6
7
8
9
10
11
12
If traveling at speeds under 20 km/h (12
mi/h), “_ _._” is displayed.
Average fuel consumption
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either “AVE_ _._ km/L” or
“AVE_ _._ L/100 km” or “AVE_ _._
MPG” as well.
“AVE_ _._ km/L”: The average dis-
tance that can be traveled on 1.0 L
of fuel.
“AVE_ _._ L/100 km”: The average
amount of fuel necessary to travel
100 km.
“AVE_ _._ MPG”: The average
distance that can be traveled on
1.0 US gal of fuel.
To switch the average fuel consump-
tion display settings, push the bottom
set button until the display changes.
To reset the average fuel consumption,
select it by pushing the bottom set but-
ton. The average fuel consumption dis-
play will flash for a few seconds. While
the display is flashing, push the top set
button until the display is reset.
After resetting the average fuel con-
sumption, “_ _._” will be shown until the
vehicle has traveled 1 km (0.6 mi).
Coolant temperature
This display shows the coolant temper-
ature from 104 F to 242 F in 1 F in-
crements.
If the message “HI” flashes, stop the
vehicle, then stop the engine and let it
cool. (See page 7-37.)
When the coolant temperature is
below 104 F, “Lo” will be dis-
played.
The coolant temperature varies
with changes in the weather and
engine load.
1. Average fuel consumption display
1. Coolant temperature display
1
BAE-28199-12.book 8 ページ ２０２０年７月２８日 火曜日 午前１０時８分
To Next Page
Loading...
