PERIODIC MAINTENANCE AND MINOR REPAIR
6-3
6
9 * Wheels
• Check runout, spoke tightness and for damage.
• Tighten spokes if necessary.
√√√√√
10 * Tires
• Check tread depth and for damage.
• Replace if necessary.
• Check air pressure.
• Correct if necessary.
√√√√ √
11 * Wheel bearings • Check bearing for looseness or damage. √√√√
12 * Swingarm • Check operation and for excessive play. √√√√
13 Drive chain
• Check chain slack, alignment and condition.
• Adjust and lubricate chain with a special O-ring chain lu-
bricant thoroughly.
Every 500 km and after washing the motorcycle or
riding in the rain
14 * Steering bearings
• Check bearing play and steering for roughness. √√√√√
• Lubricate with lithium-soap-based grease. Every 20000 km
15 * Chassis fasteners
• Make sure that all nuts, bolts and screws are properly
tightened.
√√√√ √
16 Sidestand
• Check operation.
• Lubricate.
√√√√ √
17 * Sidestand switch • Check operation. √√√√√ √
18 * Front fork • Check operation and for oil leakage. √√√√
19 *
Shock absorber assem-
bly
• Check operation and shock absorber for oil leakage. √√√√
20 *
Rear suspension relay
arm and connecting
arm pivoting points
• Check operation. √√√√
21 * Fuel injection • Adjust engine idling speed. √√√√√ √
22 Engine oil
• Change.
• Check oil level and vehicle for oil leakage.
√√√√√ √
NO. ITEM CHECK OR MAINTENANCE JOB
ODOMETER READING (× 1000 km)
ANNUAL
CHECK
1 10203040
U5VKE1E0.book Page 3 Tuesday, July 18, 2006 1:00 PM
To Next Page
