Yamaha XVS950CU - License Plate Light; Replacing the Auxiliary Light Bulb

PERIODIC MAINTENANCE AND ADJUSTMENT
6-30
6
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10681]
EAU24330
License plate light
If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
EAU45225
Replacing the auxiliary light
bulb
If the auxiliary light bulb burns out, re-
place it as follows.
1. Remove the headlight unit. (See
page 6-28.)
2. Remove the auxiliary light bulb
socket (together with the bulb) by
pulling it out.
3. Remove the burnt-out bulb by pull-
ing it out.
1. Turn signal light bulb
1
1. Auxiliary light bulb socket
1
U2DXE0E0.book Page 30 Monday, June 24, 2013 9:30 AM