10
Pre-testing on skin
When using the device for the first time, always test for compatibility.
1 2 3
CAUTION
How to hold the device and use it on your skin
Be sure to perform a pre-test in order to prevent skin problems from occurring.
If a rash, redness, itchiness, stinging sensation, or other abnormality occurs at the pre-testing area, immediately stop the
pre-test.
Check carefully that your skin is not showing any abnormalities during the treatment. Stop using the device immediately if
the treatment does not agree with your skin.
Remove all metal accessories (watches, necklaces, rings, earrings, etc.) when using the device. Failure to comply may cause
an accident or an injury.
The recommended ambient temperature is between 10 °C and 40 °C.
Wash the inner side of your arm
with a soap and water, then
wipe dry with a towel.
Apply the included skin care product
(about one pearl-sized drop) to the
center of the electrode head, turn the
power on, and then use the device for
about three minutes while moving it
over the skin (page 13).
Be sure to test at Level 1.
Rub the skin care products
remaining on your skin into the
skin and check for any
abnormalities.
Continue to use the product only if you
experience no reddening or burning
sensation on your skin within 24 hours.
Hold the main unit as shown below, moving
it slowly so that the entire electrode head
remains in contact with your skin.
• Be sure to move the device with the entire
electrode head in contact with your skin.
To Next Page
Loading...
Need help?
General
