Yamato VG Series User Manual

1. Installation
1.3.3 Release of thread cutting operation
Relese or use of thread cutting operation can be
set by [iJ key.
While
display I 0 J is above the [1] key lights,
thread cutting operation is released.
'
1.4 Adjusting synchronizer
On the machine with a UT/UT-A device, check the
needle stop position is between the highest point
and the point 0. 5 mm below the highest point.
Loosen the screws CD to move the synchronizer®
right or left to adjust its position.
tt If the needle stops before the highest posi-
tion, move the synchronizer® to the left. (Fig.
7)
tt If the needle stops after the highest position,
move the synchronizer® to the right. (Fig. 8)
Then run the machine to check the needle stop
position.
VG/Y
20
. ..................................................................................... ..
1 a. o o
Fig. 6
Fig. 7
N
Fig. 8
From the library of: Superior Sewing Machine & Supply LLC

Yamato VG Series Specifications

General

Brand	Yamato
Model	VG Series
Category	Sewing Machine
Language	English