Yara N-Sensor V3.10 Operation Manual
+/-: This button changes the menu to allow for manual application rate changes in
steps of +10% and –10%. If rates are manually changed, the change factor is dis-
played below the indicator bar.
Marker: If this button is pressed the menu changes to the marker menu, which allows
to set and delete three markers independently from each other. If markers are set,
the respective area will be marked in the log data output and in the map printout,
respectively. This option may be helpful to identify specific areas within the field
during fertilizer application.
Usually, the system should be activated at the beginning of the field and should con-
tinue to operate throughout the whole field. The Stop button is only pressed to pause
operation within the field, i. e. in order to refill fertilizer. In the headlands, the N-Sensor
keeps running. The fertilizer distributor is operated as without the N-Sensor connected,
i. e. it is closed and opened in the headlands as usual.
When the field is completed, press the Stop button to deactivate the system.
You may now continue with another task on another field as described in
section
4 or remove the data card and process the log-file(s).
Last revised: 28.01.2009 14:39 Page 39 of 64
To Next Page
Loading...
Need help?
General
