- 8 -
STEP 1: Attach the Angle Bracket to Sweeper Housing
1. Assemble the angle bracket to the sweeper housing using M8x16 hex bolt and M8 hex lock
nut.
NOTE: Make sure the bracket is turned as shown and aligned straight with the housing and
tighten.
NOTE: Right Hand (RH) and Left Hand (LH) are determined from the operators’ position while
seated on the vehicle.
STEP 2: Attach Hitch Tubes to the Sweeper Housing
1. Assemble the RH hitch tube to the sweeper housing using M6x45 hex bolt and M6 lock nut.
Only loosely tighten.
2. Repeat for the LH hitch tube, loosely tighten.
To Next Page
Loading...