16 17
Vibration and noise reduction
To reduce the impact of noise and vibration emission,
limit the time of operation, use low vibration and low
noise operating modes as well as wearing personal
protective equipment.
Take the following points into account to minimize the
vibration and noise exposure risks:
1. Only use the product as intended by its design and
these instructions.
2. Ensure that the product is in good condition and well
maintained.
3. Keep tight grip on the handles/gripping surface.
4. Maintain this product in accordance with these
instructions and keep it well lubricated (where
appropriate).
5. Plan your work schedule to spread any high vibration
tool use across a longer period of time.
Servicing
1. Have your tool repaired by an authorised service
agent. This tool is manufactured in accordance with
the relevant safety regulations. To avoid danger,
equipment must only be repaired by qualied
technicians.
2. Only use parts and accessories made for this
appliance by the manufacturer. Failure to do so can
result in personal injury.
Safety symbols
The purpose of safety symbols is to attract your
attention to any possible dangers. The safety symbols
and their explanations deserve your careful attention
and full understanding. The symbol warnings do not, by
themselves, eliminate any danger. The instructions and
warnings they give are no substitute for proper accident
prevention measures.
WARNING:
Be sure to read and understand
all safety instructions within this operator’s
manual, including all safety alert symbols such as
“DANGER”
,
“WARNING”
, and
“CAUTION”
before
using this tool. Failure to follow all instructions
listed below may result in electric shock, re and/or
serious personal injury.
SAFETY ALERT SYMBOLS:
Indicate
DANGER,
WARNING,
or
CAUTION.
May be used in conjunction
with other symbols or pictographs.
Symbol meanings
This page depicts and describes safety symbols that may
appear on this product. Read, fully understand and follow
all instructions on the appliance before attempting to
assemble and operate.
PRODUCT SAFETY WARNINGS SYMBOLS
To Next Page
