To Next PageTo Next PageHow to fix a Yard force EW U15 that is not running?
If your Yard Force Pressure Washer isn't running, first, make sure the power outlet is switched ON. Then, release any residual pressure by pressing the spray gun trigger. Ensure the ON/OFF switch is in the “I” ON position and if the motor protection has activated, allow the unit to cool down for 15 minutes.
What to do if my Yard force EW U15 motor starts but there is no pressure?
If the motor starts but there is no pressure build-up in your Yard Force Pressure Washer, start by cleaning the water filter. Also, check that the water supply is turned on and that there is no air in the supply hose.
Why does my Yard Force Pressure Washer have irregular pressure?
To address irregular operating pressure in your Yard Force Pressure Washer: * Check the supply hose and hose connection, replacing if necessary, to ensure there's no air in the inlet water hose. * Clean the water filter if it's clogged. * Straighten any kinked water supply hoses. * Check the water supply flow to ensure it's adequate.
What causes low output pressure in a Yard force EW U15?
If the output pressure of your Yard Force Pressure Washer is steady but too low, replace the high pressure hose if it's damaged. Also, hand tighten any loose high pressure screw connections.
What to do if my Yard force EW U15 is leaking?
If you notice leaks in your Yard Force Pressure Washer, hand-tighten the water intake adapter and the high pressure hose screw connections. For internal leaks, consult an authorised service centre.
General| Brand | Yard force |
|---|---|
| Model | EW U15 |
| Category | Pressure Washer |
| Language | English |
