Yard force LT G33A - Replacing The Nylon Line Spool

23
Fig 17
Trimming Edges
As shown in Fig 17
1. Guide the grass trimmer along the edge of the lawn. Avoid contacting with paved
surfaces, stone or garden walls, as this will wear the cutting line rapidly.
2. Use the edge of the guard as a guide when cutting near fences and walls, etc.
TIPS
1. For best results, do not cut wet grass because it tends to stick to the cutting head and
guard, prevents proper discharge of grass trimmings, and could cause you to slip and fall.
2. Pay special attention when performing the work close to trees and bushes. The cutting
head could damage sensitive bark, and damage fence posts.
3. Using the ower protection to avoid bringing the cutting device into contact with hard
objects such as walls and kerbstones.
Replacing The Nylon Line Spool
WARNING! Before performing any assembly, always ensure that the battery pack has
been removed. If the nylon cutting line is broken and the nylon spool needs replacing:
1. Press together the both locking devices at the spool cover and remove the spool cover.
Remove the old spool.
2. Thread the new/relled spool line through the eyehole in the trimmer head.
3. Insert the line spool so that it sits on the trimmer head.
4. Line up the release clips of the spool cover with the holes on the trimmer head and push
so that the spool cover clicks into position.
NOTE! The installation sequence .see the Fig 18 exploded view.
OPERATION