11
OPERATION INSTRUCTIONS
WARNING
Risk of injury, Do Not Direct discharge stream at self or other persons.
WARNING
Before cleaning any surface, an inconspicuous area should be cleaned
to test spray pattern and distance for maximum cleaning results.
Turn ON the pressure washer by pressing the button with mark “ I ”. The unit will run for
a few seconds to build up pressure, then will stop on the function of total stop system
(TSS)(Fig.11).
Release the spray gun trigger lock and squeeze the gun trigger until there is a steady
stream of water (Fig.12). Change the spray tip as per the recommendation above
if necessary. Before changing spray tip, switch the machine OFF, depress trigger to
release pressure and engage the triggher lock.
CAUTION
Make sure spray tip and wand is well locked. Do not move the spray tip
while trigger is depressed.
CAUTION
If painted surfaces are peeling or chipping, use extreme caution as
pressure washer may remove the loose paint from the surface.
For most cleaning applications, a twenty-ve degree (25
o
) spray angle be
recommended to avoid damage to the surface being sprayed.
Fig.12
To Next Page
Loading...
Need help?
General
