14
SHUTTING DOWN AND STORAGE
1. (If you are not using detergent, go directly to Step 2.) When you have finished
using the detergent dispensing system, ll detergent tank with clean water to rinse
the system clean. Squezze the gun trigger for one minute at low pressure so that
all detergent remaining in system are thoroughly ushed out. Empty the remaining
water, and rinse it until it is thoroughly cleaned.
2. Turn off water supply and disconnect the garden hose from the faucet and the
water inlet on the unit.
3. Squeeze the gun trigger for a few seconds to release any remaining water until
water spray stops, turn o unit immediately.
4. Unplug power cord from the power outlet and wrap it then can store it in the side
storehousing.
5. Disconnect the high-pressure hose from the gun wand and wrap it, then can store
it in the back storehousing.
6. Engage gun trigger lock and disconnect the quick-connect wand from trigger
handle, disassemble and replace the spray tip to tip holder on the unit, insert the
wand into the wand holder, turn back the handle to the down position.
7. Store the machine and accessories in a room that does not reach freezing
temperatures. Do not store near furnace or other sources of heat as it may dry out
the pump seals.
WARNING
Turn o water supply and squeeze trigger to depressurize the unit. Failure
to do so could result in personal injury due to discharge of high- pressure Water.
Optimum Winterizing Procedure
Winterizing your pressure washer will help protect and prolong its life. We strongly
recommend you follow the below steps using *Pressure Washer Pump Saver.
This will keep the internal parts lubricated, protected from rust, and prevents the pump
from freezing.
1. Connect Pressure Washer Pump Saver hose
onto the water inlet.
2. Depress button on top of pump saver
container.
3. Continue until uid exits the high-pressure
hose for 15 seconds.
4. Remove the hose from pump inlet (water inlet).
*Pressure Washer Pump Saver not included
Fig.16
To Next Page
Loading...
Need help?
General
