9
ASSEMBLY AND OPERATION INSTRUCTIONS
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Garden hose
must be at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall
below 2 GPM (gallons per minute) [9.1 LPM (liters per minute)]. Flow rate can be
determined by running the water for one minute into an empty 5-gallon (19 L) container.
The water supply temperature must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in water contaminated with
solvents (e.g. paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we
recommend checking the water lter (located inside the water inlet. To
clean it out, see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean
water source and an additional accessory water lter if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every 30
minutes of use.
MACHINE ASSEMBLY
Fig. 4
Attach hand cranks onto the hose reel and cord reel on both sides.
To Next Page
Loading...
Need help?
General
