EasyManuals Logo

Yard force YF2200LC User Manual

Yard force YF2200LC
21 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
ASSEMBLY AND OPERATION INSTRUCTIONS
3. Turn off the pressure washer by pressing the switch button with mark “ O ”, activate the safety latch for
a break. For storage, drain machine after use by removing water connection, turning ON the machine for 3
seconds and depressing gun trigger to release remaining water in the pump. Turn OFF immediately. (Fig. 18)
CLEANING DETERGENTS DISPENSER
Only use cleaning detergents recommended for pressure washers.
Always follow detergent manufacturer’s label recommendations for proper use of detergents or soap. Al-
ways protect eyes, skin and respiratory system from detergent if used.
CAUTION
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure water to
penetrate and remove the dirt more effectively.
To apply detergents, you must be operating at low pressure. This provides a gentle application of
detergent, with the pressure equivalent to the lowest garden hose. The high-pressure setting is
used for cleaning, you cannot apply detergents when working at high pressure.
Always test detergent in an inconspicuous area before use.
NO BLEACH!
1. Engage gun safety lock.
Fig. 19 Fig. 20
2. Attach the low-pressure spray tip (black) for soap or detergent application. Detergent application will
only work with low pressure spray tip.
3. As shown Fig.20 remove the cap of detergent tank, ll tank with detergent or soap and replace the cap.
Apply detergent as instructed by the detergent manufacturer.
4. Turn on the pressure washer. Squeeze trigger to operate unit. The liquid detergent will automatically mix
with water, and be discharged through the nozzle. Apply detergent to work surface, from bottom to top.
5. Allow detergent to remain on the surface for a short time before rinsing. Do not allow detergent to dry
on surface.
6. Rinse with clean water under high pressure. On a vertical surface, rinse from the bottom up, then rinse
from the top down to avoid streaking. Hold nozzle 8-10” from the cleaning surface, at a 45° angle.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yard force YF2200LC and is the answer not in the manual?

Yard force YF2200LC Specifications

General IconGeneral
BrandYard force
ModelYF2200LC
CategoryPressure Washer
LanguageEnglish

Related product manuals