17
Water Filter Screen
The pressure washer is equipped with a water inlet lter screen to protect the pump. If the screen is not
kept clean, the ow of water to the pressure washer will be restricted and the pump may be damaged.
1. To clean inner water screen, remove the inlet adaptor and remove the lter screen from the pump inlet.
2. Rinse screen until it is free of debris and blockage.
3. Replace screen immediately to prevent any foreign matter from entering the pump.
CLEANING AND MAINTENANCE
Fig. 22
A clogged water lter screen can cause excessive pressure to build-up in the pressure washer’s pump. The
wand’s water lter screen should be cleaned regularly to avoid damaging the wand or pump. For new pur-
chase please call at 1-(866) 902-9690.
4. Using needle-nose pliers, carefully take the water lter screen out of the wand.
5. Clean the water lter screen by carefully inserting the water lter cleaning tool provided or a thin and
sharp instrument (e.g. paperclip) into the lter to remove any dirt deposited. Rinse with clean water.
6. Using needle-nose pliers, carefully reinsert the water lter screen into the wand. Ensure the screen ts
tightly into the wand’s water inlet opening.
Main body cleaning
Use only mild soap and damp cloth to clean the main body.
WARNING
Never use the unit to clean itself.
Connections
Connections on pressure washer hoses, gun and spray wand should be cleaned regularly and lubricated
with non-water soluble grease.
Spray Tips Only
Clogging of the spray tips causes the pump pressure to be too high and cleaning is immediately required.
Clean the spray tips by carefully inserting the needle provided into the tip to remove any dirt deposited.
WARNING
To assure product safety and reliability, repairs should be performed by authorized service
centers or other qualied service personnel, always use identical replacement parts.
Fig. 23
To Next Page
Loading...
Need help?
General
