19
Pump is noisy. Pump is sucking air. Check that hoses and ttings are airtight.
Turn off machine and purge pump by
squeezing trigger gun until a steady ow of
water emerges through the nozzle.
Water lter is clogged. Remove water lter and rinse in warm
water.
Water leaks from pump
(up to 10 drops per
minute is permissible).
Loose ttings. Check that all ttings are tight.
Water seals are damaged or worn. Call the Toll-Free Hot line.
Oil is dripping. Oil seals are damaged or worn. Call the Toll-Free Hot line.
Motor buzzes but fails
to run.
Supply voltage below minimum. Verify that only the pressure washer is
running on this circuit.
System has residual pressure. Turn unit OFF, squeeze trigger on spray
wand to release pressure, then turn unit
ON.
Voltage loss due to extension cord. Unplug any extension cords attached and
plug the unit directly into the outlet.
Pressure washer not used for long
periods.
Call the Toll-Free Hot line.
Residual friction among components.
Unit might hum.
Disconnect water supply and power ON
for 2 to 3 seconds, repeat couple times or
until the motor starts.
No water. Water supply is OFF. Turn ON water supply.
Kink in the garden hose. Remove kink in garden hose.
If you have any questions, visit our website for key FAQ’s, downloadable troubleshooting steps,
instructional videos, and replacement parts purchase at www. ForceToolsUSA.com, or call our toll free hot
line: 1-(866) 902-9690.
TROUBLE SHOOTING
To Next Page
Loading...
Need help?
General
