17
TROUBLE SHOOTING
WARNING
！
Before performing any repair work, always ensure that the battery pack/safety key has been removed
and wait until the blade has stopped completely and the tool has cooled down .
WARNING
！
Always wear heavy duty gloves when adjusting or cleaning ,especially when handling sharp objects.
Fault/malfuncti
on
Cause Remedy
Mower fails to start Safety key is not inserted Insert safety key
Battery is not correctly inserted Remove the battery and reinsert
Mower standing in high grass Start motor on shorter grass or already
mowed area ;change cutting height if
necessary
The mower housing is clogged Clean housing so that the blade can
move freely
Battery has no power check and recharge battery
Mower stops working /
loses power
Cutting height is improper Adjust the cutting height
Discharge chute/ housing is blocked Clean the discharge chute/ housing
Cutting blade is worn or damaged Replace with New blade from dealer
service centre
Battery performance decreasing
Mower Overloaded -Red light
displayed switch box
Check the battery performance and
charge it if necessary
Wait until reset occurs – Green light
displayed on switchbox
Grass bag is not lled
suciently
Cutting height is too Low Adjust and increase cutting height
The lawn / grass is wet Allow the lawn to dry
Discharge chute/ housing is blocked Clean the discharge chute/ housing
Underside of the mower deck is
clogged.
Clean the underside of the mower deck
Cutting blade is worn or damaged. Replace it by the customer service
center
Mower vibrating at high-
er speed
Cutting blade is unbalanced Balance the blade by grinding each
cutting edge equality
Blade is Loosened /incorrectly tted Tighten the blade bolt
Mower does not mulch
properly
Cutting height set to low
Deck has wet grass on underside of
deck
Adjust cutting height
Clean underside of deck and wait until
grass is dry
Mower cuts unevenly The blade is damaged
Blade is assembled incorrectly
Sharpen the blade or replace
Re-assemble blade correctly
To Next Page
Loading...
Need help?
General
