EasyManua.ls Logo

YARD KING Performance 50565x89 - BEFORE YOU MOW; ASSEMBLY

YARD KING Performance 50565x89
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BEFORE YOU MOW
ASSEMBLY
This instruction book isfor several models. Some parts oraccesso-
ries are not included on all models. Read and follow the assembly
and adjustment instructions for your mower. Do not discard any
parts or material untilthe unit is assembled.
A WARNING: Before doing any assembly or mainte-
nance to the mower, remove the wire from the spark
plug.
NOTE: In this Instruction book, left and right describe the loca-
tion of a part with the operator on the seat.
CHECK THE TIRES
Check the air pressure inthe tires. "13reswith too much air pressure
will cause the unit to ride rough. Also, the wrong air pressure will
keep the mower housing from cuttinglevel. The correct airpressure
(PSI) is 14 PSI (1 BAR). The tires were over inflated for shipment.
CHECK THE LEVEL OF THE MOWER HOUSING
Make sure the level of cut is still correct. After you mow a short
distance, lookat the area that was cut. Ifthe mower housing does
not cut level, see the instructions on "How To Level The Mower
Housing" in the Maintenance section of this instruction book.
MAINTENANCE FREE BA'I-rERY
IMPORTANT: Before you attach the battery cables to the
battery, check the battery date. The battery date tells If the
battery must be charged.
t. Check the top of the battery for the location of the battery date
(Figure t).
2. If the battery is put into service before the battery date, the
battery cables can be attached without charging the battery.
See "How To Install The Battery Cables".
3. If the battery is put into service after the battery date, the
battery must be charged. See "How To Charge The
Maintenance Free Battery".
HOWTOCHARGETHEMAINTENANCEFREEBATrERY
A
1.
2.
3.
4.
WARNING: When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
Remove the battery and battery tray.
Remove the protective caps from the battery terminals.
Use a 12 volt battery charger to charge the battery. Charge at
a rate of 6 amperes for one hour. if you do not have a battery
charger, have an authorized service center charge the battery.
Install the battery and battery tray. Make sure the positive (+)
terminal is on the left side.
712008 9

Related product manuals