5
SECTION 2: IMPORTANT INFORMATION FOR LOG SPLITTER USERS
Always:
• Use clean fluid and check fluid level regularly
• Use Dexron III Automatic Transmission Fluid
or 10W non-foaming hydraulic fluid.
• Use a filter (clean or replace regularly)
• Use a breather cap on fluid reservoir
• Keep end of reservoir return tube below fluid
level
• Make certain pump is mounted and aligned
properly
• Use a flexible ‘‘spider’’ type coupling between
engine and pump driveshafts
• Keep hoses clear and unblocked
• Bleed air out of hoses before operating
• Flush and clean hydraulic system before start-
up after any malfunction or servicing
• Use ‘‘pipe dope’’ on all hydraulic fittings
• Allow time for warm-up before splitting wood
• Prime the pump before initial start-up by
turning over the engine with spark plug
disconnected
• Split wood with the grain (lengthwise) only
Never:
• Use when fluid is below 20
°
F.,
or above 150
°
F.
• Use a solid engine/pump coupling
• Force pump when mounting
• Operate through relief valve for more than
several seconds
• Attempt to adjust unloading or relief valve
settings without pressure gauges
• Operate with air in hydraulic system
• Use Teflon tape on hydraulic fittings
• Warm up engine apart from pump in cold
weather
• Attempt to cut wood across the grain
SECTION 3: FINDING YOUR MODEL NUMBER
This Operators Manual is an important part of your
new log splitter. It will help you assemble, prepare
and maintain your log splitter. Please read and
understand what it says.
Before you start to prepare your log splitter for its
first use, please locate the model plate and copy the
information from it in this Operators Manual. The
information on the model plate is very important if
you need help from your dealer or the MTD
customer support department.
• Every log splitter has a model plate. You can
locate it by standing behind the unit in the
operating position and looking down at the
hydraulic tank. .
Figure 1
MTD PRODUCTS INC
CLEVELAND, OHIO 44136
XXX-X-XXX-X-XXX XXXXXXXXXXX
Model Number
Serial Number
Copy the model number here:
Copy the serial number here:
To Next Page
Loading...