StoringYourChipperShredderVacuum
• Clean the equipment thoroughly.
• Wipe equipment with an oiled rag to prevent rust.
• Refer to engine manual for correct engine storage
instructions
• Store unit in a clean, dry area. Do not store next to
corrosive materials such as fertilizer.
WARNING: Never store the machine or
fuel container indoors where there is an
open flame, spark, or pilot light such as on
a water heater, furnace, clothes dryer, or
other gas appliance.
SECTION7: TROUBLESHOOTING
Problem Cause Remedy
Engine fails to start
Engine runs erratic
1. Spark plug wire disconnected.
2. Fuel tank empty or stale fuel.
3. Throttle control lever not in correct
starting position.
4. Choke not in CHOKE position
(If Equipped).
5. Engine (if equipped with a primer)
not primed properly.
6. Blocked fuel line.
7. Faulty spark plug.
1. Spark plug wire loose.
2. Unit running on CHOKE
(If Equipped).
3. Blocked fuel line or stale fuel.
1. Connect wire to spark plug.
2. Fill tank with clean, fresh gasoline.
3. Move throttle lever to FAST position.
,
5.
6.
1.
1.
2.
3.
1.
4. Move choke to CHOKE position.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.
Loose parts or damaged impeller.
Engine oil level low.
Dirty air cleaner.
Carburetor not adjusted properly.
Spark plug gap too close.
5. Prime engine.
6. Clean fuel line.
7. Clean, adjust gap, or replace.
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF position.
,
,
5.
6.
1.
1.
2.
3.
1.
Clean fuel line; fill tank with clean, fresh
gasoline.
Drain fuel tank. Refill with fresh fuel.
Clean or replace air cleaner.
See authorized service dealer.
Too much vibration See authorized service dealer.
Engine overheats Fill crankcase with proper oil.
Clean or replace air cleaner.
See authorized service dealer.
Occasional skip (hesitates) Adjust gap to.030".
at high speed
Unit does not discharge 1. Discharge chute clogged. 1.
Rate of discharge slows
considerably or
composition of discharged
material changes
2. Foreign object lodged in impeller.
3. Lowengine RPM.
4. Vacuum bag is full.
1. Low engine RPM.
2. Chipper blade dull.
Stop engine immediately and
disconnect spark plug wire. Clean flail
screen and inside of discharge opening.
2. Stop engine and disconnect spark plug
wire. Remove lodged object.
3. Always run engine at full throttle.
4. Empty bag.
1. Always run engine at full throttle.
2. Replace chipper blade or see your
authorized service dealer.
NOTE: For repairs beyond the minor adjustments fisted above, contact your nearest authorized service dealer.
13
To Next Page
Loading...
Need help?
General
