OPERATION
16
CONNECTING TO POWER SUPPLY (See Figure 7)
This chainsaw is designed with a cord retainer that prevents the extension cord from being
pulled loose while using.
• Form a loop with the end of the extension cord.
• Insert loop portion of extension cord through the opening in the side of the rear handle, and
place over cord hitch.
• Slowly pull loop against cord retainer until the slack is removed.
• Plug chainsaw into extension cord.
NOTE: Failure to remove all excess cord slack from extension cord retainer could result in
plug loosening from receptacle.
Fig. 7
EXTENSION
CORD
To Next Page
Loading...
Need help?
General
