OPERATION
15
APPLICATIONS
You can use this product for the purposes listed below:
• Basic limbing, felling, and woodcutting
• Removing buttress roots
ADDING BAR AND CHAIN LUBRICANT (See Figure 6)
Use a lubricant that is designed for chains and chain oilers, and is formulated to perform over
a wide temperature range with no dilution required.
NOTE: The chainsaw comes from the factory with no bar and chain oil added. Level should
also be checked after every 20 minutes of use, and refilled as needed.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil.
• Check and fill the oil tank when quick-view oil indicator is below the MIN. line.
• Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar
or chain.
NOTE: It is normal for oil to seep from the saw when not in use. To prevent seepage, empty
the oil tank after each use, then run for one minute. When storing the unit for a long period of
time (three months or longer), be sure the chain is lightly lubricated. This will prevent rust on
the chain and bar sprocket.
WARNING:
Do not allow familiarity with this product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side shields when operating power tools.
Failure to do so could result in objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this
product. The use of non-recommended attachments or accessories can result in serious
personal injury.
N
I
A
H
C
T
N
A
C
I
R
B
U
L
OIL RESERVOIR
CAP
Fig. 6
To Next Page
Loading...
Need help?
General
