MAINTENANCE
30
• Release the tip of the guide bar, and turn the chain tensioning knob 1/2 turn clockwise.
• Hold the tip of the guide bar up and tighten the chain cover lock knob.
The chain is correctly tensioned when there is no sag on the underside of the guide bar, and
when the chain is snug, but can be turned by hand without binding.
NOTE: If chain is too tight, it will not rotate. Loosen the chain cover lock knob slightly, and turn
the chain tensioning knob 1/4 turn counter-clockwise. Lift the tip of the guide bar up, and
retighten the chain cover lock knob. Ensure that the chain will rotate without binding.
To Next Page
Loading...
Need help?
General
