To Next Page

To Previous Page

MAINTENANCE

Use only a low-kickback chain on this saw. This fast-cutting chain provides kickback reduction

when properly maintained.

For smooth and fast cutting, maintain the chain properly.The chain requires sharpening when

the wood chips are small and powdery, the chain must be forced through the wood during

cutting, or the chain cuts to one side. During maintenance of the chain, consider the following:

,PSURSHUILOLQJDQJOHRIWKHVLGHSODWHFDQLQFUHDVHWKHULVNRIVHYHUHNLFNEDFN

5DNHUGHSWKJDXJHFOHDUDQFH

ż7RRORZLQFUHDVHVWKHSRWHQWLDOIRUNLFNEDFN

ż1RWORZHQRXJKGHFUHDVHVFXWWLQJDELOLW\

,IWKHFXWWHUWHHWKKLWKDUGREMHFWVVXFKDVQDLOVDQGVWRQHVRUDUHDEUDGHGE\PXGRUVDQG

on the wood, have an authorized service centre sharpen the chain.

NOTE:,QVSHFWWKHGULYHVSURFNHWIRUZHDURUGDPDJHZKHQUHSODFLQJWKHFKDLQ,IVLJQVRI

wear or damage are present in the areas indicated, have the drive sprocket replaced by an

authorized service centre.

NOTE:,I\RXGRQRWIXOO\XQGHUVWDQGWKHFRUUHFWSURFHGXUHIRUVKDUSHQLQJWKHFKDLQDIWHU

reading the instructions that follow, have the saw chain sharpened by an authorized service

centre or replace with a recommended low-kickback chain.

CHAIN MAINTENANCE (See Figure 32)

CAUTION:

Make sure the chainsaw is disconnected from the power supply before you work on the

saw.

Fig. 32

RAKER (DEPTH GAUGE) CLEARANCE

1/32"

(0.6 mm)

Yardworks 054-5753-0 User Manual

Questions and Answers: