OPERATION
17
STARTING AND STOPPING THE CHAINSAW (See Figure 8)
WARNING:
Keep body to the left of the chain line. Never straddle the saw or chain, or lean over past
the chain line.
Starting the chain saw:
• Make sure chain tension is at desired setting. Refer to Adjusting the Chain Tension in the
Maintenance section of this manual.
• Make sure the chain cover lock knob is tight to the chain cover.
• Make sure no objects or obstructions are in immediate vicinity which could come into
contact with the bar and chain.
• Press and hold the switch lock. This makes the trigger switch operational.
• Press and hold the trigger switch, release the switch lock, and continue to squeeze the
trigger switch for continued operation.
Stopping the chainsaw:
NOTE: It is normal for the chain to coast to a stop once the trigger switch is released.
• Release the trigger switch to stop the chainsaw.
• Upon release of the trigger switch, the switch lock will be automatically reset to the lock
position.
Fig. 8
TRIGGER
SWITCH
SWITCH
LOCK
To Next Page
Loading...
Need help?
General
