Yardworks 060-1526-0 User Manual

model number 060-1526-0 | contact us: 1 866 523-5218 model number 060-1526-0 | contact us: 1 866 523-5218
10 11
Operation Safety and Maintenance
CHECKING THE ADJUSTMENT
The cutting mechanism is preset. After a long period of use it may need to be
readjusted. Check cutting performance and adjust if necessary.
1. Adjust the space between reel blades and cutter bar.
2. Turn the screw clockwise to move the lower blade towards the spindle blade.
Turn the screw counter-clockwise to move the lower blade away from the
spindle blade.
3. When the space equals the thickness of paper (0.12 mm), insert a piece of
paper between the blades and the cutter bar, and quickly turn the wheel by
hand.
4. All blades should slice the paper evenly.
WARNING: Clean any grinding compound or debris from
cutter bar blade, reel blade, pinions and pawls.
NOTE:Use industrial or value tapping compound between 100
wheel bearing grease.
such as dandelions and may bend the weeds instead of cutting
them. Cut often to prevent long weeds from growing. When
lengths are long weeds and tall grass will fold before contacting
the cutting bar.
!
!
IMPORTANT SAFETY INFORMATION
•
reel. Although a motor does not power this
mower, when the wheels turn the reel spins
and poses a cutting risk.
• Never mow when grass is wet as it can be
slippery.
• Do not use the reel mower while barefoot or
while wearing sandals.
• Walk behind and never run while using reel
mower. Always make sure of your footing
when using this reel mower.
• Never intentionally strike or hit trees, fences,
etc. This can cause injuries or severely
damage the reel mower mechanisms.
• Make sure your reel mower is in a safe
operating condition.
or have the
provider before using.
CARE AND MAINTENANCE
1. A minimum amount of care is required to
ensure smooth operation of your mower.
2.To avoid damage to mower or cutting
blades, keep area to be mowed free of
debris.
3. For best results, regularly apply lubricant
to mower’s cutting surfaces, cutting reel
axle shaft and wheels.
SHARPENING THE CUTTING BLADES:
1. Spread a thin layer of lapping compound
on the front edge of the reel blades.
2. Adjust the cutter bar so that the blade has
the cutter bar.
Caution: Do not overtighten the adjusting
screws, as this could damage the cutter bar.
3.Turn the reel blades until the front edge of the
cutter bar blade is polished.
CLEANING AND STORAGE:
1.Clean the exterior of the machine thoroughly
using a soft brush and cloth before storing.
Do not use water, solvents or polishes.
2.Turn the mower on its side to clean the
blade area.
WARNING:
Do not place hands in the mower
near blades. If grass cuttings are compacted in
the blade area, remove using a wood or plastic
cleaning tool appropriate for the cleaning of the
blades.
3. Store the mower in a dry place. Do not place
other objects on top of the mower during storage.
CARE AND MAINTENANCE
Maintenance tip:
Reel mowers are relatively low maintenance.
For consistent cutting follow these below
instructions:
• Always keep the cutting bar properly
adjusted. Refer to the instruction manual for
further directions.
• Regularly clean and lube cutting edges with
light spray oil.
Made in China. Imported by YardWorks Canada Toronto,
Canada M4S 2B8
!
d
d
=
=
0,12mm
1
2
3
4
• Do not attempt to operate this reel mower if
damaged. Contact customer service
reel

Yardworks 060-1526-0 Specifications

General

Brand	Yardworks
Model	060-1526-0
Category	Lawn Mower
Language	English