model no. CBV48CU | contact us: 1.866.523.5218 model no. CBV48CU | contact us: 1.866.523.5218
13
OPERATION
BEFORE PUTTING INTO OPERATION
1. CHARGING THE BATTERY (SEE FIG. B)
a. The battery in your new tool is not charged when it leaves the plant. Therefore it must
be fully charged before using the rst time.
b. If the battery pack is very hot, remove the battery from the charger and allow it to cool
to ambient temperature before attempting to recharge.
c. To prevent damage to the battery pack, please charge the battery to full or no less
than half charge before storage.
d. If the tool will not be used for long periods of time, charge the battery pack every 3-6
months.
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger; make sure the battery is in the correct charge
position rmly. The light will begin ashing green to indicate the charging process has
started.
3) When charging is completed, the light will turn solid green.
4) When the battery is fully charged, unplug the charger and remove the battery pack.
NOTE: If the battery pack is locked in the charger, press the battery pack release button
and remove it.
WARNING: When battery charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the battery to
cool down before re-charging to achieve the full charge.
WARNING! The charger and battery pack are specially designed to
work together, so do not attempt to use any other devices. Never
insert or allow metallic objects into your charger or battery pack
connections because an electrical failure and hazard will occur.
Operation
To Next Page
Loading...
Need help?
General