- 08 -
Power cable for damage
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners
Daily check
Before each use
Before each use
Before each use and frequently
Before each use, visual check
Before each use
Before each use
TRANSPORTATION AND STORAGE
1. Stop the machine, disconnect from mains and allow it to cool before storing or transporting.
2. Clean all foreign material from the product. Store it in a cool dry and well-ventilated place that is inacces-
sible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts. Do not
store outdoors.
3. Cover the saw bar with the scabbard before storing the unit, or during transportation.
4. When storing the unit for a long period of time (one month or longer), be sure the chain is lightly lubricat-
ed to prevent rust.
5. For transportation, secure the machine to avoid damage to the machine.
MAINTENANCE
WARNING:
Use only original manufacturer’s replacement parts, accessories and attachments.
WARNING:
For service we suggest you return the product to your nearest authorised service centre for repair.
When servicing, use only identical replacement parts.
WARNING:
Change or removing the chain scabbard, and always wear protective gloves when performing
maintenance to the chain.
WARNING:
Improper chain maintenance increases the potential of kickback.
2. For other repairs, contact the authorised service agent.
3. Follow instructions for lubricating and chain tension .
4. After each use, clean the body and handles of the product with a soft dry cloth.
5. Check all nuts, bolts and screws at frequent intervals for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be properly repaired or replaced by an authorised
service centre.
MAINTENANCE SCHEDULE
The bar may be reversed to distribute wear for maximum life. The bar should be cleaned every day of use
and checked for wear and damage.
The product is only intended for use outdoors. For safety reasons the product must be adequately controlled
by using two handed operation.
The product is designed for cutting and pruning of small limbs and branches whose diameter is less than
or equal to the bar length, which are high in the tree whilst the operator maintains a steady footing on the
ground. The product is designed to be extended to a maximum length of 9’2”. Do not exceed this working
length.
To Next Page
