15
TROUBLESHOOTING
Adjust the height of the handle, and verify
that the carriage bolts are properly seated.
Tighten the knobs.
Verify that the Snow Thrower is plugged into
an electrical outlet.
Press and hold the lock-out button, and then
lift and hold the trigger switch (see the
section entitled Starting the Snow Thrower).
Replace the belt (see the section entitled
Inspecting/Replacing the Drive Belt).
Replace the scraper (see the section entitled
Replacing the Scraper).
The carriage bolts are not properly
seated
The Snow Thrower is unplugged.
The lock-out button or trigger switch
were not used properly.
The belt is damaged.
The scraper is worn
Then handle is not in
position.
The Snow Thrower
does not start.
The motor is on, but
the rotor does not turn.
The belt is damaged.
The Snow Thrower
leaves a thin layer of
snow behind.
Problem Possible Causes Solutions
To Next Page
Loading...
Need help?
General
