model no. 054-5775-8 | contact us: 1.866.523.5218 model no. 054-5775-8 | contact us: 1.866.523.5218
11
Fig. 4
2
2/3
1
1/3
When the log is supported on both ends, as
illustrated in Figure 5, cut 1/3 the diameter
from the top (overbuck) (1). Then make the
nished cut by underbucking (2) the lower 2/3
to meet the rst cut.
Fig. 5
1
2
2/3
1/3
When bucking on a slope always stand on
the uphill side of the log, as illustrated in
Figure 6. When “cutting through”, to maintain
complete control, release the cutting pressure
near the end of the cut without relaxing your
grip on the chainsaw handles. Don’t let the
chain contact the ground. After completing
the cut, wait for the saw chain to stop before
you move the chainsaw. Always stop the
motor before moving from tree to tree.
Fig. 6
Safety Instructions
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
WARNING: Changes or modications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
To Next Page
Loading...
Need help?
General
