To Next Page

To Previous Page

model no. 054-5775-8 | contact us: 1.866.523.5218

BEFORE OPERATION

1. CHARGING YOUR BATTERY PACK

NOTE:

a) The battery in your new tool is not charged when it leaves the plant; therefore, it must be

full charged before using the rst time.

b) If the battery pack is very hot, remove the battery from the charger and allow it to cool to

ambient temperature before attempting to recharge.

c) To prevent damage to the battery pack, please charge the battery to full or no less than

half charge before storage.

d) If the tool will not be used for long periods of time, charge the battery pack every 3-6

months.

CHARGING PROCEDURE (SEE FIG. B)

1) Plug the charger into an appropriate outlet.

2) Slide the battery pack into the charger rmly. Make sure the battery is in the

correct charge position. The light will begin ashing green to indicate the

charging process has started.

3) When charging is completed, the light will become solid green.

4) When fully charged, unplug the charger and remove the battery pack.

WARNING! The charger and battery pack are specially designed

to work together—do not attempt to use any other devices. Never

insert or allow metallic objects into your charger or battery pack

connections because an electrical failure and hazard will occur.

WARNING: When battery charge runs out after continuous use or

exposure to direct sunlight or heat, allow time for the battery to

cool down before re-charging to achieve the full charge.

Operation

Yardworks CCS48BCU User Manual

Questions and Answers: