model no. 054-5775-8 | contact us: 1.866.523.5218
22
CHARGING INDICATOR
This charger is designed to detect some problems that can arise with battery packs.
Indicator lights indicate problems (see table below).
2. TO REMOVE OR INSTALL BATTERY PACK (SEE FIG. C)
1) REMOVING
Depress the battery pack release button rmly rst and then lift the battery pack up to
remove from your tool.
2) INSTALLING
Place the fully charged battery pack into the tool until it clicks into position.
Operation
Light ON/ Flash Status
Red on
Defective battery.
Red ash
Battery Temperature Protection.
The temperature of battery pack is
less than 0
o
C (32
o
F) or more than
40
o
C (104
o
F).
Green on
Fully charged.
Green ash
Charging.
To Next Page
Need help?
General
