To Next Page

To Previous Page

model no. 054-5775-8 | contact us: 1.866.523.5218

Important: The chainsaw is not lled with oil. It is essential to ll

with oil before use. Never operate the chainsaw without chain

oil or at an empty oil tank level, as this will result in extensive

damage to the product.

Important: To allow proper ventilation of the oil tank, small

breather channels are provided between the oil ller cap and the

strainer to prevent leakage. Ensure machine is left in a horizontal

position when not in use.

Caution: Do not touch the ground with the chain. Ensure safety

clearance of 12” (30 cm).

Filling oil tank:

WARNING: Remove the battery pack before lling the oil tank.

Assembly

LUBRICATION

NOTE: Chain life and cutting capacity depend on optimum lubrication. Therefore, the chain

is automatically oiled during operation.

1. Set chainsaw on any suitable surface with oil ller cap facing upward.

2. Clean area around the oil ller cap with a cloth, and unscrew the cap by turning it

counter-clockwise.

3. Add chain oil until tank is full.

4. Avoid dirt or debris entering oil tank. Ret oil ller cap and tighten by turning clockwise

until hand tight.

It is important to use only the recommended bar and chain oil to avoid damage to the

chainsaw. Never use recycled/old oil. Use of non-approved oil will void the warranty.

Do not swallow. If swallowed, call a physician immediately. Keep out of reach of

children. Store away from heat or open ame.

Checking the Automatic Oiler

Proper functioning of the automatic oiler can be checked by running the chainsaw and

pointing the tip of the chain guide bar towards a piece of cardboard or paper on the ground.

If an increasing oil pattern develops on the cardboard, the automatic oiler is operating ne. If

there is no oil pattern, despite a full oil reservoir, contact a CTC customer service agent or a

CTC-approved service agent.

Yardworks CCS48BCU User Manual

Questions and Answers: