model no. 054-5775-8 | contact us: 1.866.523.5218
18
5. Fit the chain onto the drive sprocket. Ensure the bar tensioning plate is facing outward.
(see Fig. A4, A5.)
6. Ensure all parts are seated properly. Make sure the drive links are fully seated in the
drive sprocket (see Fig. A6.), avoid placing the chain in the inverse direction 9 (see Fig.
A7.) If kink occurs, pick up on the chain at the guide bar just ahead of the kink and then
pull the kink out.
NOTE: Chain should rotate freely and be free of kinks.
A5
A4
A7
A6
Assembly
To Next Page
Loading...
