To Next Page

To Previous Page

model no. 054-5775-8 | contact us: 1.866.523.5218 model no. 054-5775-8 | contact us: 1.866.523.5218

Injecting grease to lubricate

Replace the guide bar when the groove is worn, the guide bar is bent or cracked, or when

excessive heating or burring of the rails occurs. If replacement is necessary, use only

the guide bar specied for your saw in the repair parts list or on the decal located on the

chainsaw.

Replacing Bar and Chain

Replace chain when cutters are too worn to sharpen or when chain stops. Only use

replacement chain noted in this manual.

Inspect guide bar before sharpening chain. A worn or damaged guide bar is unsafe. A worn

or damaged guide bar will damage chain. It will also make cutting harder.

Sharpening the Saw Chain

Cutting edges on chain are sharp. Use protective gloves when handling chain.

Keep chain sharp. Your saw will cut faster and more safely. A dull chain will cause undue

sprocket, guide bar, chain, and motor wear. If you must force chain into wood, and cutting

creates only sawdust with few large chips, the chain is dull.

NOTE:

It is not necessary to remove the chain or bar when lubricating the guide bar sprocket.

1. Clean the bar and sprocket.

2. Using a grease gun, insert the tip of the gun into the lubrication hole and inject grease

until it appears at the outside edge of the sprocket tip. (see Fig. J.)

3. To rotate the sprocket, pull the chain by hand until the ungreased side of the sprocket is

in line with the grease hole. Repeat the lubrication procedure.

WARNING! Remove the battery pack before servicing. Severe

injury or death could occur from electric shock or body contact

with moving chain.

WARNING: Wear heavy-duty gloves when performing any

maintenance or service to this tool.

Always remove the battery pack before performing any service or

maintenance on this tool.

Maintenance

Yardworks CCS48BCU User Manual

Questions and Answers: