Yardworks CGT48CU - Operation and Trimming; Switching the Trimmer On and Off; Trimming Techniques

model no. 060-1983-0 | contact us: 1.866.523.5218
14
WARNING: Always wear eye protection. Never lean over the
trimmer head. Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other serious injury.
WARNING: Make sure that line is fed out before operation. Make sure
motor is up to full speed before trimming.
1. SWITCH ON/OFF
To switch on, press the lock-off button rst, then the On/Off Switch. (See Fig. F.)
To switch off, release the On/Off Switch.
2. TRIMMING
1) Keep the trimmer head at an angle of about 30° to the ground when trimming. (See Fig. G1.)
2) Do not cut wet grass because it tends to stick to the trimmer head and guard, prevents
proper discharge of grass clippings, and could cause you to slip and fall.
3) Regularly remove clippings and dirt around the trimmer head. Ensure the trimmer is
switched off.
4) Work rhythmically; stand rmly with your feet apart. Cut from right to left so the trimmings
will be thrown away from the work area. (see Fig. G2.)
5) When cutting longer/high grass, please make sure that you cut it down in 2 to 3 stages.
(see Fig. G3, G4.).
6) Do not move the trimmer too fast as this will result in ineffective cutting and possible damage.
A2
A1
B
E
E
G1
F
G3
G2
H
G4
I2
I1
I4
I3
J1
J2
C2
C1
1
2
1
2
1
1
2
Locking/
Release knob
Guide recess
13
14
30
0
2
1
A2
A1
B
E
E
G1
F
G3
G2
H
G4
I2
I1
I4
I3
J1
J2
C2
C1
1
2
1
2
1
1
2
Locking/
Release knob
Guide recess
13
14
30
0
2
1
A2
A1
B
E
E
G1
F
G3
G2
H
G4
I2
I1
I4
I3
J1
J2
C2
C1
1
2
1
2
1
1
2
Locking/
Release knob
Guide recess
13
14
30
0
2
1
Operation