model no. 060-1980-6 | contact us: 1.866.523.5218model no. 060-1980-6 | contact us: 1.866.523.5218
14
ASSEMBLY
1. ASSEMBLING THE LOWER HANDLE.
1) Insert the lower handle, washer, lower locking knob into the screw on the deck (See Fig. A1).
2) Turn the locking knob clockwise and tighten it. (See Fig. A2).
3) Repeat for the other side.
4) Check that the handles are FULLY secured.
2. ASSEMBLING THE UPPER HANDLE.
1) Insert the screw with circle washer into the hole of lower handle, hole of the upper handle,
square washer, locking knob (See Fig. B1, B2, B3).
NOTE: There are two holes in the upper side of lower handle. Select the hole according to
the required height of operating handle.
2) Tighten the handle knob clockwise (See Fig. B4).
3) Repeat for the other side.
4) Check that the handles are FULLY secured.
To reduce the risk of injury, user must read instruction manual
Intended Use
This product is intended for domestic lawn mowing.
• Mowing with grass collection bag attached—Standard lawn mowing with grass
collection bag attached.
• Mulch and Mowing—Use the mower without the grass collection bag attached. The
lawn mower will mulch as it cuts and the ne grass clippings are distributed back onto
the grass surface without leaving piles of grass clippings.
Assembly
CAUTION! The machine must not be put in operation before it has been
assembled completely.
CAUTION! Do not insert the battery until the appliance has been completely
assembled.
To Next Page
Loading...
Need help?
General
