37
• Mounting/Removing Components
Removing and Mounting Digital Operator and Covers
• Removing front cover
Use a screwdriver to loosen the screw on
the front cover surface to direction 1 to
remove it. Then press the right and left
sides to direction 2 and lift the front cover
to direction 3.
• Mounting front cover
Insert the tab of the upper part of the front
cover into the groove of the inverter. Press
the lower part of front cover onto the
plastic case until the cover snaps shut.
Tighten the screws.
• Removing option cover
After removing front cover, remove the
option cover to direction 2 with section A
as a supporting point.
• Mounting option cover
Mount the terminal cover in the reverse
order of the above removal procedure.
• Removing upper/bottom covers
After removing front cover, lift the top and
bottom covers to direction 1.
• Mounting upper/bottom covers
Mount the front cover in the reverse order
of the above removal procedure.
To Next Page
Loading...
