4
Placing a Call
Answering a Call
Ending a Call
Call Mute and Un-mute
Redial
Call Hold and Resume
To place a call on hold:
Using the handset:
Using the speakerphone:
Using the headset:
Using the handset:
Using the speakerphone:
Using the headset:
Using the handset:
Using the speakerphone:
Using the headset:
1. With the handset on-hook, press
.
1. Pick up the handset.
2. Enter the number, and then press the
Send soft key.
1. With the headset connected, press
to activate the headset mode.
2. Enter the number, and then press the
Send soft key.
2. Enter the number, and then press the Send soft key.
Pick up the handset.
Press
.
Hang up the handset or press the End Call soft key.
Press
.
Press or the End Call soft key.
Press the
End Call soft key.
Press
to enter the Placed Calls list, press or to select the desired entry, and then press
or the Send soft key.
Press twice when the phone is idle to dial out the last dialed number.
To resume the call, do one of the following:
Press to mute the microphone during a call.
Press again to un-mute the call.
If there is only one call on hold, press or the Resume soft key.
Press or the Hold soft key during an active call.
Basic Call Features
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by
pressing the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires
a connected headset.
Note: You can reject an incoming call by pressing the Reject soft key.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
