Yealink SIP-T2XP - Downloading and Verifying Configurations; Downloading Configuration Files; Verifying Configurations

Getting Started
19
 Add local contacts between <root_contact> and </root_contact>.
 At most 1000 local contacts can be added to IP phones.
 When specifying a desired line for a contact, valid values are -1~6. This is not
applicable to SIP-T19P and CP860 IP phones.
(For SIP-T21P/T20P, valid values are 0~2. For SIP-T26P/T22P, valid values are 0~3. For
SIP-T28P, valid values are 0~6. 0 stands for Auto (the first registered line).1~6 stand
for line1~line6.
For SIP-T42G/T41P, valid values are -1~2. For SIP-T48G/T46G, valid values are -1~5.
-1 stands for Auto (the first registered line). 0~5 stand for line1~line6. Multiple line
IDs are separated by commas.)
 When specifying a ring tone for a contact, valid values are Auto,
Resource:RingN.wav (system ring tone, integer N ranges from 1 to 5 for
SIP-T2xP/T19P/T42G/T41P/CP860 and from 1 to 8 for SIP-T48G/T46G) and
Custom:Name.wav (custom ring tone).
 When specifying a group for a contact, valid values are the group names (built-in
or custom groups).
 When specifying an avatar for a contact, valid values are “Default: avatar name”
(for the built-in avatar) and “Config: avatar name” (for the custom avatar). This is
only applicable to SIP-T48G/T46G IP phones.
To customize a local contact file:
1. Open the template file using an ASCII editor.
2. For each group that you wish to add, add the following string to the file. Each starts
on a separate line:
<group display_name=”” ring=””/>
Where:
display_name=”” specifies the name of the group.
ring=”” specifies the ring tone for this group.
3. For each contact that you wish to add, add the following string to the file. Each
starts on a separate line:
<contact display_name=”” office_number=”” mobile_number=”” other_number=””
line=”” ring=”” group_id_name=”” default_photo=””/>
Where:
display_name=”” specifies the name of the contact (This value cannot be blank or
duplicated).
office_number=”” specifies the office number of the contact.
mobile_number=”” specifies the mobile number of the contact.
other_number=”” specifies the other number of the contact.