EasyManuals Logo

Yealink SIP-T31P Getting Started

Yealink SIP-T31P
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Recovery Mode on Yealink IP phones
11
For W52P/W56P/W60B Base
For the W52P/W56P/W60B base, there is no screen to show information for you. The W52P/W56P/W60B
base uses 192.168.0.100 as its default IP address, so you need to configure a static IP address for your
local PC where you have the TFTP server installed.
Procedures
1. Configure the static IP address on your local PC.
It must be configured as below:
2. Click OK twice to save the settings.
3. Long press (for W52P/W56P base) or (for W60B base) and reconnect the power adapter
to trigger the recovery mode. Do not release (for W52P/W56P base) or (for W60B base)
until three LED indicators ( -> -> in turn) are all turned on.
The W52P/W56P/W60B base will download and upgrade the firmware from the TFTP server.
You can view the syslog of the TFTP server to check if the W52P/W56P/W60B base downloads the
firmware successfully as shown below:

Other manuals for Yealink SIP-T31P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T31P and is the answer not in the manual?

Yealink SIP-T31P Specifications

General IconGeneral
Resolution132 x 64 pixels
Network10/100 Mbps Ethernet
PoEYes
PoE ClassClass 2
SIP Accounts2
Wall MountableYes
Local Phonebook1000 entries
HD VoiceYes
Display2.3-inch graphical LCD
Voice CodecsG.722, G.729AB, G.726, iLBC
Headset SupportYes
Protocols SupportedSIP
Power SupplyOptional 5V/600mA power adapter

Related product manuals