Yealink SIP-T33G Recovery Guide

Recovery Mode on Yealink IP phones
14
You can view the syslog of the TFTP server to check if the W80DM/W80B downloads the firmware
successfully as shown below:
4. Find the current IP address of the device on the DHCP server in the list of registered DHCP clients.
For W90DM/W90B
For the W90DM/W90B, there is no screen to show information for you. The W90DM/W90B uses
192.168.0.23 as its default IP address, so you need to configure a static IP address for your local PC
where you have the TFTP server installed.
Procedures:
1. Configure the static IP address on your local PC.
It must be configured as below:

Yealink SIP-T33G Specifications

General

Wall Mountable	Yes
Local Phonebook	1000 entries
Opus Codec	Yes
Lines	4
Supported Codecs	Opus, G.722, G.711(A/μ), G.729AB, G.726, iLBC
Headset Port	RJ9
Network	Dual-port Gigabit Ethernet
PoE	Yes (IEEE 802.3af)
Audio Features	HD voice
SIP Accounts	4
Buttons	4 context-sensitive soft keys
Headset Support	Yes
Supported Protocols	SIP
Operating Temperature	0 ~ 40°C
Humidity	10% to 90% (non-condensing)