Media IP Phone – SIP-T52S
ANSWERING A CALL
Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press .
ENDING A CALL
Using the handset:
Hang up the handset or press the EndCall soft key.
Using the speakerphone:
Press or the EndCall soft key.
Using the headset:
Press the EndCall soft key.
REDIAL
• Press to enter the Placed Calls list, press or to select the desired entry, and then press
or the Send soft key.
• Press twice when the phone is idle to dial out the last dialed number.
CALL MUTE AND UN-MUTE
• Press to mute the microphone during a call.
• Press again to un-mute the call.
CALL HOLD AND RESUME
To place a call on hold:
Press the Hold soft key during an active call.
To resume the call, do one of the following:
• If there is only one call on hold, press the Resume soft key.
• If there is more than one call on hold, press or to select the desired call,
and then press the Resume soft key.
CALL TRANSFER
You can transfer a call in the following ways:
Blind Transfer
1. Press the Tran soft key during an active call. The call is placed on hold.
2. Enter the number you want to transfer to.
3. Press the Tran soft key.
Semi-Attended Transfer
1. Press the Tran soft key during an active call. The call is placed on hold.
2. Enter the number you want to transfer to, and then press .
Note:
•
You can reject an incoming call by pressing the Reject soft key.
To Next Page
Loading...
