EasyManuals Logo

Yealink SIP-T53 Recovery Guide

Yealink SIP-T53
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Recovery Mode on Yealink IP phones
9
6. Press to verify the current firmware version after upgrading successfully.
Note
Using Recovery Mode on Yealink IP Phones
(TFTP Server)
This section introduces how to perform recovery mode using the TFTP server on Yealink IP phones step
by step.
For SIP Phone Series
This section is only applicable to SIP phone series including MP54, MP56, MP58, VP59, SIP-T58A, SIP
VP-T49G, SIP-T57W, SIP-T54W, SIP-T53W, SIP-T53, SIP-T19P, SIP-T19(P) E2, SIP-T21(P) E2,
SIP-T23P/G, SIP-T27G, SIP-T29G, SIP-T33P/G, SIP-T31P/T31G/T31, SIP-T30P/T30, SIP-T40P/G,
SIP-T41P/S, SIP-T42G/S, SIP-T46G/S, SIP-T48G/S, CP920 and CP860.
The following procedures take the SIP-T46G IP phone for reference.
Procedures
1. Long press (Speakerphone key) and reconnect the power adapter to trigger the recovery
mode. Do not release until the recovery mode wizard appears on the phone LCD screen.
Note
2. Enter the desired values in the IP Address, Netmask, IP Gateway and TFTP Server fields
respectively.
For CP860/CP920, you need to long press the specified soft key (the second from the left on the
phone) since there is no Speakerphone key. For CP920/CP925, press 1 to use the TFTP server.
For MP54, MP56, MP58, VP59, SIP-T58A/T57W/T54W/T53W/T53/T48U/T48S/T46U/T46S/T43U
/T42U/T42S/T41S IP phones, you need to press 1 on the recovery mode selection screen to use
TFTP server. For more information, refer to For MP54/MP56/MP58/VP59/SIP-T58A/T57W/T54W/
T53W/T53/T48U/T48S/T46U/T46S/T43U/T42U/T42S/T41S/CP920 IP Phones.
You need to tap Settings->Status (for SIP-T58A IP phones) or press (for SIP-T3 IP phones)
to verify the current firmware version since there is no key.

Other manuals for Yealink SIP-T53

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T53 and is the answer not in the manual?

Yealink SIP-T53 Specifications

General IconGeneral
NetworkDual-port Gigabit Ethernet
SIP Accounts12
Lines12
Stand IncludedYes
PoEYes (IEEE 802.3af)
USB Port1 x USB 2.0
Headset SupportRJ9 and USB
Audio FeaturesHD Voice
Expansion Module SupportYes, up to 3
Voice CodecsG.722, G.711
Network FeaturesIPv4/IPv6, VLAN, QoS
Local Phonebook1000 entries
MountingDesk mount, Wall mount
Power SupplyOptional
Weight1.1 kg
Resolution360 x 160

Related product manuals