S-Series IP PBX Administrator Guide
71
features such as outbound routes. The PIN can also be presented in the CDR record.
Go to Settings > PBX > Call Features > Pin List and click to add Pin list.
Figure 7-13 Add PIN List
Linking a PIN List to Outbound Routes/DISA
After creating PIN lists, you can link the PIN lists to Outbound Routes or DISA. On outbound
route/DISA edit page, you can select the PIN list from the Password drop-down menu.
Paging/Intercom
Intercom is a feature that allows you to make an announcement to one extension via a phone
speaker. The called party does not need to pick up the handset. It is can be achieved by pressing the
feature code on your phone and it is a two-way audio call.
The default Intercom feature code is *5. To make an announcement to a specific extension, you need
to dial *5+ extension number on your phone. For example, make an announcement to extension 500,
you need to dial *5500, then the extension 500 will be automatically picked up.
Paging is used to make an announcement over the speakerphone to a phone or group of phones.
Targeted phones will not ring, but instead answer immediately into speakerphone mode. Paging is
typically one way for announcements only, but you can set the paging group as a duplex mode to
allow all users in the group to talk and be heard by all.
To Next Page
Loading...
Need help?
General
