yeedi DVX46 - Navigation and Stuck Issues

28
EN
No. Scenario Possible Cause Solution
4
Robot misses cleaning
spots to be cleaned,
or repeats cleaning the
area cleaned�
The cleaning cycle is interfered by small objects or
barriers on the oor.
Remove power cords and small objects from the oor
to ensure cleaning efciency. Robot will automatically
clean the area missed, please avoid moving Robot
manually or block the path during the cleaning cycle�
Robot is working on slippery polished oors.
Make sure the oor wax is dried before Robot starts
cleaning�
Robot is unable to reach certain areas blocked by
furniture or barriers�
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place�
5
Robot gets stuck while
working and stops�
Robot gets stuck while working and stops�
Robot will try various ways to free itself� If it is
unsuccessful, manually remove the obstacles and
restart�
Robot might be stuck under furniture with an
entrance of similar height�
Please set a physical barrier�
6
Robot is making too
much noise when
cleaning�
Robot is tangled or blocked with debris�
Clean Robot as described in section Maintenance and
restart� If the trouble persists, please contact Customer
Care�
7
Shaft Sleeve of the Main
Brush falls off�
Shaft Sleeve gets entangled by debris and falls off
during the cleaning�
Please clean up the debris and reinstall it�